• MIPI I3C specification v1.1
• AMBA, Advanced Peripheral Bus (APB) Specification Version 2.0
• AMBA, Advanced High-performance Bus (AHB) Specification Version 2.0
• AMBA, Advanced eXtensibale Bus (AXI) Specification Version 4.0
• AMBA, Advanced eXtensibale Lite Bus (AXI-Lite) Specification Version 4.0

DTI I3C Controller supports:

• Two wire serial interface up to 12.5 MHz using Push-Pull
• Legacy I2C Device co-existence on the same Bus (with some limitations)
• Dynamic Addressing while supporting Static Addressing for Legacy I2C Devices
• Legacy I2C messaging
• I2C-like Single Data Rate Messaging (SDR)
• Optional High Data Rate Messaging Modes (HDR-DDR, HDR-TSL, HDR-TSP)
• Support for Multi-master (transferring the ownership of the bus to a Secondary Master if Present)
• Reception of In-band Interrupt Support from the I3C Slave devices
• Reception of Hot-Join from newly added I3C Slave devices
• Synchronous Timing Support and Asynchronous Time Stamping
• Master only operation
• Slave only operation
• Master and slave operation

DTI I3C Master supports:

• Transmission modes: Single Data Rate (SDR) Mode
• Dynamic Address Assignment
• Host-join request
• Secondary master request to be current master
• Slave interrupt request
• Support for I3C common command codes
• Error Detection and Recovery Methods for SDR

DTI I3C Slave supports:

• Transmission modes: Single Data Rate (SDR) Mode
• Dynamic Address Assignment
• Host-join
• In-Band Interrupt
• Error Detection and Recovery Methods for SDR
• Detect HDR Exit Pattern
• Support for I3C common command codes:
  • Broadcast CCCs
    • RSTDAA
    • ENTDAA
    • ENEC, DISEC
    • ENTAS0, ENTAS1, ENTAS2, ENTAS3
    • SETMWL, SETMRL
  • Direct CCCs
    • SETDASA
    • SETNEWDA
    • GETSTATUS
    • ENEC, DISEC
    • ENTAS0, ENTAS1, ENTAS2, ENTAS3
    • SETMWL, SETMRL
    • GETMWL, GETMRL
    • GETMXDS
    • GETPID, GETBCR, GETDCR
    • GETXTIME

Data Sheets are available under NDA

REQUEST NDA